The SCM-2S WP is a small and durable electronic speed controller that is suitable for Micro RC vehicles of all types! The SCM-2S WP is also fully waterproof, making it the only choice for anyone who enjoys driving their car in wet conditions.
The SCM-2S WP is suitable for 5-6 NiMH cells, as well as 2S LiPo with a low voltage safety cut-off fitted to protect your LiPo batteries.
Specification:
- FWD Cont. / Burst Current : 25A/100A
- BWD Cont. / Burst Current : 25A/100A
- Input : 2S LiPo, 5-6 Cells NiMH / NiCd
- Motor Limit 2S LiPo or 6 NI-MH : 280, 370 or 380 Size
Motor RPM<30000 @7.2V
- Resistance : Fwd 0.003Ω, Rev 0.003Ω
- Built-in BEC : 1A / 6V (Linear Mode)
- Dimension / Weight : 34x24x14mm / 23.5g
NOTE: Before driving in wet conditions, make sure that other electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant - we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts.
